الهاتف:0086

EN
جميع الاقسام

الأخبار الصناعية

الصفحة الرئيسية>مواقع الأخبار>الأخبار الصناعية

كيفية الحفاظ على الفلتر الأساسي القابل للطي بإطار الألومنيوم؟

الوقت: 2022-08-03

The production material of aluminum frameطوى primary filter.

Filter material: non-woven filter cotton;

Sealant: universal adhesive;

Frame material: aluminum profile, paper frame, aluminum plate, galvanized;

Filtration efficiency: G3, G4;

Maximum temperature: 80℃;

Maximum humidity: paper frame: 80%, metal frame: 100%.

طريقة إنتاجهيكل من الألومنيومطوى مرشح أساسي.

1. Welded wire guard mesh with surface anti-rust treatment and fixed linear pleated structure, not easily deformed during use.

2. Sealed connection at the connection of filter media and outer frame to prevent the occurrence of air leakage at the connection of filter media and outer frame.

3. Adopt high quality chemical fiber filter media, wire mesh fixed filter media.

4. The shaped structure of the filter media can fully utilize the filtering area to improve its dust capacity.

استخدم مكان:Aluminum frameطوى مرشح أساسي is a common pre-filter for ventilation system.

التخصيص:SFFILTECH can customize the products according to your needs.

Cleaning steps ofهيكل من الألومنيومطوى مرشح أساسي.

1. open the suction grille in the equipment and gently pull it down by pressing the buttons on both sides.

2. drag the hooks on the air filter and pull out the equipment to the bottom at an angle.

3. remove the dust from it with a vacuum-like device, or rinse it with warm water.

4. If you encounter too much dust you can use a soft brush with neutral detergent to clean it, shake the water dry after cleaning and place it in the shade to dry.

5. Do not use more than 50 ℃ hot water for cleaning, so as not to lose color or deformation of the equipment, and do not dry on the fire.

6. After the cleaning is completed, be sure to install the equipment in time, the installation of the equipment will be hung on the upper part of the inhalation grille protrusion, and then fixed on top of the inhalation grille, the back of the inhalation grille convex handle slowly slide inward until the entire equipment will be pushed into the grille;

7. The last step is to close the suction grille, which is exactly the opposite of the first step, press and hold the filter signal reset button on the control panel, then the cleaning reminder will disappear.

  SFFILTECH reminds you that if the primary filter is used in an environment with too much dust, then the number of times of cleaning should be increased according to the situation, generally once every six months is appropriate.


المدونة